Compaq StorageWorks SSL2000 Series Reference Manual page 8

viii Compaq StorageWorks SSL2000 Series Library Reference Guide
Figure 3-5. Unplugging the PTM motor housing assembly control cable .............. 3-7
Figure 3-6. Connecting a patch cable...................................................................... 3-9
Figure 3-7. Connecting to Library units................................................................ 3-10
Figure 3-8. Location stop pin................................................................................ 3-11
Figure 3-9. Attaching tie bars ............................................................................... 3-12
Figure 3-10. Attaching PTM extrusions................................................................ 3-13
Figure 3-11. Attaching tie bars to the PTM extension .......................................... 3-14
Figure 3-12. Cutting the belt ................................................................................. 3-15
Figure 3-13. Threading the belt through the pulleys ............................................. 3-16
Figure 3-14. Attaching the belt clamp bracket...................................................... 3-17
Figure 3-15. Replacing the bottom pulley end cap ............................................... 3-18
Figure 3-16. Snapping the spring over the tension post ........................................ 3-19
Figure 3-17. PTM layout....................................................................................... 3-20
Figure 3-18. Releasing the elevator car................................................................. 3-21
Figure 3-19. Disengaging the wheels.................................................................... 3-22
Figure 3-20. Removing the elevator car................................................................ 3-23
Figure 3-21. Aligning the belt tensioner ramp ...................................................... 3-24
Figure 3-22. Removing tension from the belt ....................................................... 3-25
Figure 3-23. Releasing the bottom pulley assembly ............................................. 3-26
Figure 3-24. Removing the bottom pulley assembly ............................................ 3-26
Figure 4-1. Library front panel ................................................................................ 4-2
Figure 4-2. Library control panel ............................................................................. 4-4
Figure 4-3. Library menus ..................................................................................... 4-11
Figure 4-4. Magazine in place................................................................................ 4-22
Figure 4-5. Tape magazine with cartridges installed ............................................. 4-23
Figure 4-6. Mail slot location................................................................................. 4-24
Figure 4-7. Tape cartridge write protection switch ................................................ 4-25
Figure 4-8. Bar code label size............................................................................... 4-26
Figure 6-1. Troubleshooting flowchart ................................................................... 6-3