Table of Contents
Advertisement
4. Press Enter to move the cursor to the second line.
5. Use the θ and π buttons to change the option to Master.
6. Press Enter to save the selection.
NOTE: The change will not take effect until you reboot.
The Slave Unit
You can configure the slave unit on the work bench before installation or after
it is installed in a storage cabinet. If you configure it when it is already
installed as part of a multi-unit Library system, be sure to either shut off power
to the master unit or disconnect the serial cables. This lets you access Menu
mode directly, thus avoiding communication interference from the master unit.
Each slave unit must have a unique one digit ID that you specify as part of the
configuration procedure. You must stack and number the units as follows:
To configure the slave unit:
1. From the Default Screen, press Enter to display the main menu.
υ Load/Unload
Remove Magazine
Maintenance Menu
Configure Menu
2. Press the θ button three times to move the υ to the Configure menu, then
press the Enter button. The following Configure submenu appears. The
⁄ at the end of the fourth line means you can scroll to additional
configuration options using the θ button.
υ SCSI Options
Library Options
Barcode Options
Set Element Base
Master
Slave 0
Slave 1
Slave 2
Slave 3
⁄
⁄
Installation 2-19
Advertisement
Table of Contents
Troubleshooting
