Installing a New Belt
1. Obtain a belt from extension kit and then cut it to the appropriate length
(see Figure 3-12).
NOTE: A new full-length belt is marked 2, 3, 4, and so forth indicating where to cut per
number of Library units the PTM will service.
Figure 3-12. Cutting the belt
NOTE: The belt included with your kit accommodates up to four PTM extrusions. The belt
is marked at numbered intervals, indicating the exact length needed for your Library
system.
Installing and Removing the Pass-Through Mechanism 3-15
Number of
Length of Belt
Extrusions
2
27 inches
3
41 inches
4
55 inches
cc0037