Compaq StorageWorks SSL2000 Series Reference Manual page 51

2-24 Compaq StorageWorks SSL2000 Series Library Reference Guide
Initialize Element Status: Lets you specify the unit's response to the SCSI
INITIALIZE ELEMENT STATUS command. The possible settings are No
Inventory, Force Inventory, and Force Label Scan. The default is No
Inventory.
Unit Attn Report: Lets you select reporting of All or only One unit attention
conditions. If set to All, the unit reports all unit attention conditions in
sequence; if set to One, the unit reports only the highest priority condition. The
default is All.
SCSI Mode: Defines the loader as SCSI-2 or SCSI-3. The default is SCSI-2.
Post Recv'd Error: Enables reporting of TapeAlert informational exception
conditions with a Recovered Error sense key, when the Method of Reporting
Information Exceptions (MRIE) field is set to a value of 0x3 in Mode Page
1Ch, or if the TapeAlert Mode option is set to Rec Error (cnd). The default is
Disabled.
Tape Alert Mode: Specifies conditions for logging and reporting TapeAlert
data. The default is Logging Disabled.
I
Logging Disabled—Inhibits logging feature.
I
No Exceptions—Device should not report information exceptions.
I
Unit Attention—Report information exceptions with a Unit Attention
sense key and an ASC/ASCQ of 5D/00.
I
Rec Error (cnd)—Report information exceptions with a Recovered
Error sense key and an ASC/ASCQ of 5D/00, if Recovered Error
Reporting is enabled.
I
Rec Error (unc)—Unconditionally report information exceptions with a
Recovered Error sense key and an ASC/ASCQ of 5D/00.
I
No Sense—Report information exceptions with a No Sense sense key
and an ASC/ASCQ of 5D/00.
I
On Request— Report information exceptions with a No Sense sense key
and an ASC/ASCQ of 5D/00, only in response to an unsolicited Request
Sense command.