Omron SYSMAC mini SP10 Operation Manual page 68

Inputting the Program
Key Sequence
Memory
Card
Upload
CARDAProCo
UM: indicates the users pro-
gram, filter value, and LR size.
DR: indicates Data relay
memory's current contents.
0 PRGM TRANSFER?
A
0 PRGM TRANSFER
B
0 PRGM TRANSFER
B
END ProCo~PC
0 PRGM TRANSFER?
C
NAME =
0 PRGM DELETE?
D
U
0 PRGM
E
END
Caution
!
60
PC
A
Download
ProCoACARD
The Programming Consoles displays at different stages of the keying se-
quence are shown below.
1.PC 2.CARD
ProCo~PC
1000
DELETE
1000
Files that have been deleted cannot be recovered. Be sure that you have desig-
nated the correct file before pressing the ENT Key.
Download
ProCoAPC
Upload
PCAProCo
UM
UM+DR
D
When 1 or 2 is selected as the response to this
prompt, the display will indicate the selection by plac-
ing a flashing cursor over the corresponding number.
The display will indicate the direction of the transfer by
use of an arrow. During transfer, a cursor will flash over
the arrow.
This display indicates the transfer is complete, in this
example from the Programming Console to the PC.
When writing to a Memory Card, a file name must be
assigned to the program to allow identification. The file
name can consist of up to a maximum of 8 characters,
the allowable characters 0 through 9 and A through F.
Indicates that a file containing only the user program
called "1000" will be deleted.
Indicates that the file called "1000" has been deleted.
Section 3-5
UM
Program trans-
ferred to PC or to
Programming Con-
sole.
B
UM+DR
DR area data is usually written to
the PC directly. Hence, if both the
program and the data in the PC is
to be transferred, specify UM+DR.
Program
File name
transferred
to card.
C
B
B
Program trans-
ferred to Program-
ming Console.
File
deleted.
E