Omron SYSMAC mini SP10 Operation Manual page 132

Memory Card Initialization
Error Messages A number of errors relating to the Memory Card may occur during the pro-
gram check. If one of the following errors is shown on the display, program
transfer cannot proceed.
Error Message
NO END
END instruction cannot be found. Include an END instruction
INST
at the end of the program.
(Program address) Displayed address has the inappropriate operand or
or inappropriate instruction. Correct the program and transfer
???? it to the PC again.
ERR CARD
The program stored in the memory card contains errors.
~ ProCo
The memory card data is transferred to the
Programming Console's RAM to allow it to be checked.
Perform a program check to confirm the program.
NO
The Memory Card is not initialized, or is not supported by the
SUPPORT
Programming Console (SP10-PRO01-V1).
CARD
Initialize the Memory Card (or check the specification of the
memory card).
ERR CARD
The memory card is full. Delete unneeded files or use another
FULL
initialized Memory Card.
PTCT ON
The Memory Card protect switch is ON, or the inserted
OR EPROM
memory card is an EPROM memory card. Adjust the protect
switch, or use a RAM Memory Card.
NO MEM.
Memory Card is not inserted properly in the card slot.
CARD
Meaning/Correction
Section 4-2
125