Connecting A Video Source Using Hdbaset; Selecting A Port Configuration - Christie Mirage 304K Installation And Setup Manual

This card may or may not be included with your model. Standard inputs are subject to change.

Connecting a video source using HDBaseT

The HDBaseT port on the IMXB accepts digital video data from HDBaseT sources.
The port configurations listed below are supported.
Input configuration
One-Port
This card may or may not be included with your model. Standard inputs are subject to change.

Selecting a port configuration

Select a port configuration before you select a video source.
1. From the display panel, select INPUT.
2. To access the port configuration dialog from the input screen, select the right arrow.
You can also access the Port Configuration screen from MENU > Configuration > Input
Settings > Input Port Configuration.
3. From the Port Configuration screen, navigate the list of port configurations until you find the
selection that best matches your configuration.
The range of available configuration depends on the projector model and/or input/output
combinations. When the Default configuration is selected (Main Menu > Configuration >
Input Settings > Video Input configuration > Default), the following configurations are
supported:
• One-port
• Two-port
• Four-port quadrants
• One-port dual-input 3D (3D license-specific)
When SDVoE is selected (Main Menu > Configuration > Input Settings > Video Input
configuration > SDVoE), the one-port configuration is selected.
4. To return to the Input screen, select the left arrow.
Mirage 304K (Bm.1) Installation and Setup Guide
020-102013-12 Rev. 1 (09-2022)
Copyright © 2022 Christie Digital Systems USA, Inc. All rights reserved.
If printed, please recycle this document after use.
Connecting devices and establishing communication
Description
Enables connection of one Ethernet cable to the HDBaseT port
on the IMXB. The HDBaseT input supplies the entire video
raster.
Requirements
N/A
41