APPENDIX 4 EMC INSTALLATION GUIDELINES
Appendix 4.1 Introduction
EMC Directives became mandatory as of January 1, 1996. The subject products must have a CE mark
attached indicating that the product complies with the Directives.
As the NC unit is a component designed to control machine tools, it is believed that it is not a direct EMC
Directives subject. However, we would like to introduce the following measure plans to back up EMC
Directives compliance of the machine tool as the NC unit is a major component of the machine tools.
(1) Methods of installation in control/operation panel
(2) Methods of wiring cables to outside of panel
(3) Introduction of members for measures
Mitsubishi is carrying out tests to confirm the compliance to the EMC Directives under the environment
described in this manual. However, the level of the noise will differ according to the equipment type and
layout, control panel structure and wiring lead-in, etc. Thus, we ask that the final noise level be
confirmed by the machine manufacturer.
This section corresponds to the following Series.
M60/60S Series
Downloaded from
ManualsNet.com
APPENDIX 4 EMC INSTALLATION GUIDELINES
Appendix 4.1 Introduction
search engine
I-220