Hours Service - Greasing The Pump; Hours Service - Transmission Shaft (Pto); Hours Service - Wheel Nuts; Hours Service - Tyre Pressure - Hardi COMMANDER DELTA FORCE Instruction Book

6 - Maintenance

50 Hours Service - Greasing the Pump

When operating the pump, it must be greased every 50 hours with 30
grams of grease into each lubrication point.
μ
ATTENTION! In order to avoid excessive wear, it is important to
use a recommended lubricant! See the section "Recommended
Lubricants" for more information.
μ
ATTENTION! The pump MUST be stopped during greasing!

50 Hours Service - Transmission Shaft (PTO)

1. Check function and condition of the transmission shaft protection guard. Replace any damaged parts.
2. Lubrication. See the section "Lubrication and Oiling Plan - PTO".

50 Hours Service - Wheel Nuts

Tighten wheel nuts as follows.
Mounting wheel hub to rim plate: Torque 490 Nm.
Tightening sequence for wheel nuts: See illustration and tighten in the
numbered order.
μ
ATTENTION! Some wheel models has 10 wheel bolts. Cross-
tighten in the same way!
μ
ATTENTION! When wheels has been mounted or retightened, the
plastic nut covers must be placed on the nuts afterwards.

50 Hours Service - Tyre Pressure

Check the tyre pressure according to the table in "Technical Specifications".
€
DANGER! Never inflate tyres more than to the pressure specified in the table. Over-inflated tyres can explode and
cause severe injuries! See the section "Occasional Maintenance - Change of Tyres".
±
WARNING! If renewing tyres, always use tyres with minimum load index as specified.

50 Hours Service - Air Brakes

The air brakes are checked for leaks by the following procedure:
1. Connect the snap couplers to the tractor. Fill the trailer air tanks.
2. Check for leaks with brakes released, for example by spraying soapy water on the wheel.
3. Apply the brake up to full pressure.
4. Check for leaks with brakes applied.
124