Outside Cleaning - Use Of External Cleaning Device; Technical Residue - Hardi COMMANDER DELTA FORCE Instruction Book

Outside Cleaning - Use of External Cleaning Device

Use the External Cleaning Device to wash everything on the outside of
the sprayer.
1. Unroll the hose from the reel.
2. Engage pump speed to approximately 250 rpm or 560 rpm,
depending on pump model.
3. Turn suction SmartValve towards "Suction from Rinsing tank" and
pressure SmartValve towards
4. Turn on ball valve (position A) and clean the sprayer.
5. After cleaning, close the ball valve (position B) again.
6. Roll the hose to the reel again. close the ChemLocker cover.
€
DANGER! Before turning Pressure SmartValve to
important to ensure that the quick coupler lid is correctly and
completely mounted to the filling stud in its locked position.
Failure to do so causes a risk of contamination and injury from quick coupler lid being "shot" off when pressurized! If
it is not possible to mount lid completely, lubricate the rubber seal and the grip hooks.
μ
ATTENTION! If the safety valve is activated, then lower the PTO speed to minimize the amount of rinsing water being
lost into the main tank.
μ
ATTENTION! If the sprayer is cleaned with a high pressure washer, lubrication of the entire machine is recommended.

Technical Residue

An amount of spray liquid will inevitably remain in the system. It cannot be sprayed properly on the crop, as the pump takes
in air, when the tank is just about empty.
This technical residue is defined as the remaining amount of liquid in the system, when the first clear pressure drop appears
on the pressure gauge.
The residual dilutable volume is approx. 47 litres. See the section "Technical Specifications" for more details.
The residues in the tank should be diluted immediately in a ratio of 1:10 with clean water. Afterwards it should be sprayed
on the crop just sprayed with increased driving speed. In addition, also pump, linkage and armature can be separately rinsed
with water from the rinsing tank. However, it must be ensured that the liquid in the spray lines are in unchanged
concentration. Therefore there should be an untreated field area available to spray this liquid out.
or not used function.
, it is very
5 - Operation
109