Maneuvering Of The Spray Boom (Ddz Type) - Hardi COMMANDER DELTA FORCE Instruction Book

5 - Operation

Maneuvering of the Spray Boom (DDZ type)

Applicable for HC 6500 / HC 8500 / HC 9500 / ISOBUS.
±
WARNING! The pendulum lock automatically turns on, when pushing one of the boom folding buttons. Folding of the
boom is not possible, if the pendulum is unlocked.
A manual override of the pendulum lock is possible by pushing
±
WARNING! Ensure that transport safety chains are removed, and that the boom is clear of the transport brackets
before unfolding.
±
WARNING! The folding functions must only be operated, when the sprayer is stationary! Failure to do so will damage
the boom. The pendulum lock automatically opens at speeds exceeding 1.5 km/h!
μ
ATTENTION! The boom can not be operated with the tractor's hydraulic levers.
To unfold the boom
±
WARNING! The pendulum lock automatically opens, when you
begin to drive. Drive slowly until the pendulum is completely
unlocked.
1. Push the button (H) to lift the boom clear of the transport brackets.
The symbol appears in display, until the pendulum is locked.
This takes approximately 10 seconds.
2. Push the button to the left (J) to unfold the inner sections
completely (approximately 5 seconds or a warning will appear).
Check that the "pendulum locked" symbol
display.
3. Push the middle button and then the right button to unfold the
other boom sections.
4. Push the button (I) to lower the boom to the correct working
height.
5. If not unlocked, then press
display, until the pendulum is unlocked. This takes approximately
10 seconds.
To fold the boom
±
WARNING! If the IntelliTrack function is installed, it must be
aligned and locked before folding.
1. Push the buttons (E) or (F) to set a neutral slant angle (no slant).
2. Push the button (H) to raise the boom to the highest possible
position.
3. Push the button to the right (K) to fold the outer section. Then push the middle button for the middle section.
The symbol appears in display, until the pendulum is locked. This takes approximately 10 seconds.
4. Push the left button to fold the inner section. Check that the pendulum lock symbol
5. Push the button (I) to lower the boom, until it is resting in the paralift locks.
6. Push the buttons (B) and (D) to lower the left and right boom sides, until they are resting in the transport brackets.
88
is visible in the
and the symbol appears in the
or .
J
A
B
E
is visible in the display.
K
H
C
D
G
I