50 Hours Service - Greasing The Pump; Hours Service - Transmission Shaft (Pto); 50 Hours Service - Tyre Pressure - Hardi COMMANDER DELTA FORCE Instruction Book

6 - Maintenance

50 Hours Service - Greasing the Pump

When operating the pump, it must be greased every 50 hours with 30
grams of grease into each lubrication point.
μ
ATTENTION! In order to avoid excessive wear, it is important to
use a recommended lubricant! See the section "Recommended
Lubricants" for more information.
μ
ATTENTION! The pump MUST be stopped during greasing!

50 Hours Service - Transmission Shaft (PTO)

1. Check function and condition of the transmission shaft protection
guard. Replace any damaged parts.
2. Lubrication. See "Lubrication and Oiling Plan - PTO" on page 142.
50 Hours Service - Wheel Nuts
Tighten wheel nuts as follows.
Mounting wheel hub to rim plate: Torque 490 Nm.
Tightening sequence for wheel nuts: See illustration and tighten in the
numbered order.
μ
ATTENTION! Some wheel models has 10 wheel bolts. Cross-
tighten in the same way!
μ
ATTENTION! When wheels has been mounted or retightened, the
plastic nut covers must be placed on the nuts afterwards.

50 Hours Service - Tyre Pressure

Check the tyre pressure according to the table in "Tyre Pressure" on
page 202.
€
DANGER! Never inflate tyres more than to the pressure specified
in the table. Over-inflated tyres can explode and cause severe
injuries! See the section "Occasional Maintenance - Change of
Tyres".
±
WARNING! If renewing tyres, always use tyres with minimum load
index as specified.
150