Daikin VAM Series Engineering Data page 172

Details of Optional Accessories
TEST RUN
(1) Make sure that the control box is closed before turning on the power supply.
(2) Turn on the power supply, then check the ventilation volume displayed on the remote controller (optional accessory).
・ Make sure that when the ventilation volume selector button is pressed, the ventilator display changes to 'Auto'. ※1
If the 'Auto' does not display, the following causes can be assumed.
a. Connection failure
b. Wire disconnection
c. Failure in the CO
After completion of the test run, check that the heat exchanger elements and air filters are installed in the correct position,
CAUTION
and the service cover and the electrical box are installed properly.
OPERATION PROCEDURE
Set the 'Fresh Up' mode by the ventilation volume selector button of the remote controller to operate with the appropriate airflow volume adjusted
depending on CO
(Setting to 'Auto' mode by the ventilation volume selector button forces the unit to operate in 'High' mode for 20 minutes) in order to decrease CO
170
o Open the electrical box and check the connection are connected properly.
o Contact your dealer.
o Contact your dealer.
sensor
2
concentration.
2
EDMMT712101
concentration.
2
JC: 2P550747-1D
VAM-HVE/HVLT Series