Table of Contents
Advertisement
USB COM (RS-232) Parameters
Intercharacter Delay
This parameter specifies the intercharacter delay between the end of one char-
acter and the beginning of the next. The delay can be set within a range of zero
(0) to 990 milliseconds in 10ms increments. A setting of zero specifies no
delay.
To set the delay:
1. Determine the desired setting in milliseconds.
2. Divide the desired setting by 10 (setting is in 10ms increments). Pad the
result with leading zeroes to yield two digits. For example: 0 = 00, 5 = 05,
20 = 20, etc.
3. Scan the ENTER/EXIT PROGRAMMING MODE bar code to enter Program-
ming Mode.
4. Scan the bar code: SELECT INTERCHARACTER DELAY SETTING on
5. Scan the appropriate two digits from the keypad in
represent the duration which was determined in the steps above. You will
hear a two-beep indication after the last character.
NOTE
6. Scan the ENTER/EXIT PROGRAMMING MODE bar code to exit Programming
Mode.
This completes the procedure. See
feature.
Table 4. Intercharacter Delay Setting Examples
STEP
ACTION
1
Desired Setting
Divide by 10 (and pad with
2
leading zeroes to yield two-
digits)
3
Scan ENTER/EXIT PROGRAMMING MODE
4
Scan SELECT INTERCHARACTER DELAY SETTING
Scan Two Characters From
5
Appendix D, Keypad
6
Scan ENTER/EXIT PROGRAMMING MODE
232
If you make a mistake before the last character, scan the CANCEL bar
code to abort and not save the entry string. You can then start again at
the beginning.
Table 4
EXAMPLES
50ms
05
'0' and '5'
Appendix D,
for some examples of how to set this
150ms
600ms
15
60
'1' and '5'
'6' and '0'
Programming Reference Guide
page
14.
Keypad, that
850ms
85
'8' and '5'
Advertisement
Table of Contents
