Ack Nak Timeout Value - HP Linear Barcode Scanner II Programming Reference Manual

Enter/Exit Programming Mode

ACK NAK Timeout Value

This option specifies the amount of time the reader waits for an ACK character
from the host following label transmission. The selectable timeout range is 200
milliseconds to 15,000ms (15 seconds) in 200ms increments. A selection of 0
disables the timeout. See
detailed programming instructions.
Select ACK NAK Timeout Value Setting
Make a mistake? Scan the CANCEL bar code to abort and
not save the entry string. You can then start again at the
beginning.
DEFAULT
18
$CR2AT
01 ACK NAK Timeout value is 200ms
"ACK NAK Timeout Value"
ACK NAK Options
on page 235 for more
~
CANCEL
Programming Reference Guide