Stand Mode Flash; Flash On Time - HP Linear Barcode Scanner II Programming Reference Manual

Reading Parameters

Stand Mode Flash

Enables/disables the LED flash when the reader is in Stand Mode.
DEFAULT
$CSMFL01
Stand Mode Flash = Enable

Flash On Time

This feature specifies the ON time for the indicator LED while in Flash Mode.
The selectable range is 100 to 9,900 milliseconds (0.1 to 9.9 seconds), in 100
millisecond increments. See
programming instructions.
$CSNFN
Select Flash ON Time Setting
Make a mistake? Scan the CANCEL bar code to abort and
not save the entry string. You can then start again at the
beginning.
Programming Reference Guide

OA = Flash is ON for 1 Second
DEFAULT
Stand Mode Flash = Disable
"Flash On Time" on page 254 for more detailed
Enter/Exit Programming Mode
$CSMFL00 
~
CANCEL
63