Stand Mode Sensitivity; Scanning Active Time - HP Linear Barcode Scanner II Programming Reference Manual

Enter/Exit Programming Mode

Stand Mode Sensitivity

Sets the sensitivity level for stand mode wakeup. Choices are low, medium and
high.
Stand Mode Sensitivity = Medium

Scanning Active Time

This setting specifies the amount of time that the reader stays in scan ON state
once the state is entered. The range for this setting is from 1 to 255 seconds in
1-second increments. See
detailed programming instructions.
Select Scanning Active Time Setting
Make a mistake? Scan the CANCEL bar code to abort and
not save the entry string. You can then start again at the
beginning.
DEFAULT
62
$CSNET
005 = Scanning is active for 5 Seconds
Stand Mode Sensitivity = Low
Stand Mode Sensitivity = High
"Scanning Active Time"
Scanning Features
DEFAULT
on page 253 for more
~
CANCEL
Programming Reference Guide