Programming Mode; Error Codes - HP Linear Barcode Scanner II Programming Reference Manual

Programming Mode

The following indications ONLY occur when the reader is in Programming Mode:
INDICATION
Label Program- A valid programming label has
ming Mode Entry been scanned.
Label Program-
ming Mode
A label has been rejected.
Rejection of
Label
In cases where multiple labels
Label Program-
must be scanned to program one
ming Mode
feature, this indication acknowl-
Acceptance of
edges each portion as it is suc-
Partial Label
cessfully scanned.
Label Program- Configuration option(s) have
ming Mode been successfully programmed
Acceptance of via labels and the reader has
Programming exited Programming Mode.
Label Program-
ming Mode Can- Cancel label has been scanned.
cel Item Entry

Error Codes

Upon startup, if the reader sounds a long tone, this means the reader has not
passed its automatic Selftest and has entered FRU (Field Replaceable Unit) iso-
lation mode. If the reader is reset, the sequence will be repeated. The following
table describes the LED flashes/beep codes associated with an error found.
NUMBER OF LED
FLASHES/BEEPS
264
DESCRIPTION
1
2
4
5
6
14 CPLD/Code Mismatch
LED
LED blinks continuously
N/A
N/A
N/A
N/A
ERROR
Configuration
Interface PCB
Reader Module
[Reserved]
Digital PCB
BEEPER
Reader sounds four low fre-
quency beeps.
Reader sounds three times at
lowest frequency & current vol-
ume.
Reader sounds one short beep at
highest frequency & current vol-
ume.
Reader sounds one high fre-
quency beep and four low fre-
quency beeps followed by reset
beeps.
Reader sounds two times at low
frequency and current volume.
CORRECTIVE
ACTION
Contact Helpdesk for assis-
tance
Programming Reference Guide