Page 1
(Voice) 845-920-0800 (Fax) 845-920-0880 HP 4430 2D Imaging Barcode Scanner This document contains barcodes for resetting the HP USB Barcode Scanner to factory defaults and for simulating a carriage return (pressing the Enter key). You can also configure the barcode scanner to scan Driver Licenses.
Page 2
Resetting the HP 2D Imaging Barcode Scanner to Factory Defaults Scan this barcode to reset all scanner parameters to factory defaults: Note: Scanning the “Set All Defaults” barcode does not change the interface type Simulating Carriage Return (Enter Key) If a carriage return/enter is required after each scanned bar code, scan the following bar...
Page 5
Driver License Configuration Barcodes Scan the following barcodes in order. This will configure the barcode scanner to scan Driver Licenses. Enter Configuration Advanced Formatting/ Label Edit Script Enable: Enabled Line 1...
Page 13
Enable Stand Mode Enable Stand Mode programs the imager to operate in stand mode, where the scanner automatically senses and reads labels with no trigger pull required. Configuration in CRE/RPE Now, you need to enable CRE/RPE to recognize the specific ID Scanners. 1.