Closing The F++ Connection; Closing The Hand Grip - Fronius THP 120 - 300 SH Service Manual

Closing the F++
connection
Closing the hand
NOTE!
grip
In the case of the water-cooled versions, the hand grip must not be closed until
the water flow rate and leak test has been carried out according to the "Testing fol-
lowing repairs" chapter.
(2)
(A)
(A) (B)
(1) (1)
(1)
Installing the hand grip
Clip the gas and optional water con-
1
nections into the insulating plate (1)
and thread the power cable (2) in
(1)
Fit the coupling housing as per
2
chapter "Replacing the coupling hous-
ing"
Close the hand grip as per the "Clos-
3
ing the hand grip" chapter
Insert the F++ connection in the lower
1
base shell as shown
Position plastic parts A and B
2
Fit the upper base shell
3
(B)
Secure both base shells with four TX 8
4
screws (1)
Tightening torque: 0.6 Nm
(1)
23