Table of Contents
Advertisement
Configuring the x530L-10GHXm Member Switches
General Steps for
the x530L-
10GHXm
Member Switch
Here are the procedures for configuring member switches of the stack.
"General Steps for the x530L-10GHXm Member Switch," next
"Configuring x530L-10GHXm Member Switches - Part I" on page 186
"Configuring x530L-10GHXm Member Switches - Part II" on page 188
"Verifying x530L-10GHXm Member Switches" on page 190
"What to Do Next" on page 199
Note
The procedures require resetting the member switch twice. Some
network traffic will be lost if the switch is already connected to an
active network.
The procedures should be performed in the order presented here.
The procedure for configuring member switches for stacking is divided into
two parts. The general steps to Part I are listed here:
1. Start a local management session on the switch.
2. View the hardware status and management software version number
with the SHOW SYSTEM ENVIRONMENT and SHOW VERSION
INSTALLLED commands in the Privilege Exec mode.
3. Enable the VCStack feature with the STACK ENABLE command in the
Global Configuration mode. You will probably not have to perform this
step because the default setting for the feature is enabled.
4. Assign an ID number in the range of 2 to 8 to the member switch with
the SWITCH RENUMBER command in the Global Configuration
mode.
Note
Changing a member switch's ID does not delete the default ID 1
from its configuration. Instead, the member switch retains it and
uses default ID 1 as the provisioned master switch.
5. Save your changes with the WRITE command in the Privilege Exec
mode.
6. Restart the switch with the REBOOT command.
x530L Series Installation Guide for Virtual Chassis Stacking
185
Advertisement
Table of Contents
