Table of Contents
Advertisement
CAUTION
CAUTION
Preparing for Calibration and Performance Verification Test
Before You Start
Before You Start
Switch on the Noise Figure Analyzer and let it warm up for 1 hour.
Read the rest of this section before you start any of the tests, and make a copy of the
relevant test records for the model you are testing provided in Appendices A
through C.
Ensure that the recommended torque settings detailed in Table 1-3 are adhered to at
all times.
Ensure that a valid ENR measurement table has been loaded from the C: or A: drive
before carrying out any performance test. The analyzer will not perform a
measurement without an ENR table loaded.
4
Chapter 1
Advertisement
Table of Contents
