Table of Contents
Advertisement
General Safety Information
The following general safety precautions must be observed during all phases of
operation, service, and repair of this instrument. Failure to comply with these
precautions or with specific warnings elsewhere in this manual violates safety
standards of design, manufacture, and intended use of the instrument. Agilent
Technologies assumes no liability for the customer's failure to comply with these
requirements.
DO NOT operate the product in an explosive atmosphere or in the presence of
flammable gasses or fumes.
DO NOT use repaired fuses or short-circuited fuseholders: For continued protection
against fire, replace the line fuse(s) only with fuse(s) of the same voltage and current
rating and type. Disconnect product from mains supply voltage before replacing
fuse.
DO NOT perform procedures involving cover or shield removal unless you are
qualified to do so: Operating personnel must not remove equipment covers or
shields. Procedures involving the removal of covers and shields are for use by
service-trained personnel only.
DO NOT service or adjust alone: Under certain conditions, dangerous voltages may
exist even with the equipment switched off. To avoid dangerous electrical shock,
service personnel must not attempt internal service or adjustment unless another
person, capable of rendering first aid and resuscitation, is present.
DO NOT operate damaged equipment: Whenever it is possible that the safety
protection features built into this product have been impaired, either through
physical damage, excessive moisture, or any other reason, REMOVE POWER and
do not use the product until safe operation can be verified by service-trained
personnel. If necessary, return the product to an Agilent Technologies Sales and
Service Office for service and repair to ensure the safety features are maintained.
DO NOT substitute parts or modify equipment: Because of the danger of
introducing additional hazards, do not install substitute parts or perform any
unauthorized modification to the product. Return the product to an Agilent
Technologies Sales and Service Office for service and repair to ensure the safety
features are maintained.
iii
Advertisement
Table of Contents
