Table of Contents
Advertisement
Step 9. As the calibration kit selection is dependant on the NFA being tested, select the
NOTE
Step 10. Select an S11 port calibration (press the
Step 11. Connect the Open to the test port or, if fitted, the adapter and perform the open
Step 12. Connect the Short to the test port or, if fitted, the adapter and perform the open
Step 13. Connect the Load to the test port or, if fitted, the adapter and perform the open
Step 14. Save the calibration (press the
Figure 2-6
Step 1. Connect the test equipment as shown in Figure 2-6 on page 35.
Step 2. Set the Network Analyzer Start/Stop to measure the DUT's input VSWR from 3000
relevant calibration kit in use from the Cal menu (press the
selection and
).
Return
The connector type applies to the test port or adaptor if fitted and not the NFA under
test.
).
Reflection 1-port
calibration (press
Opens
calibration (press
Shorts
calibration (press
Load
Measuring Input VSWR from 3000 MHz to 6700 MHz
Input VSWR Test Setup 2
VECTOR NETWORK
ANALYZER 2
Port 1
uWave Cable
Chapter 2
key, then
Cal
and then select the relevant menu key).
and then select the relevant menu key).
, select the relevant menu key
Save/recall
key and then
NOISE FIGURE
ANALYZER
Input
Test Descriptions
Input VSWR
key,
Cal
Calibration Kit
and
Calibrate Menu
and then done 1-port CAL
Save State
).
Adapter 3
).
35
Advertisement
Table of Contents
