Intermec CN3 Series User Manual page 102

Chapter 3 — Configuring the Computer
86
3 For Association, choose Open or Shared to match the
settings on your access point.
4 For Encryption, choose WEP.
5 From the Data TX Key list, select the key you want to use for
transmitting data.
6 Define a value for the keys you want to use. You can define up
to four keys (Key 1 through Key 4).
Enter an ASCII key or a hex key that is either 5 bytes or 13
bytes long depending on the capability of the radio. Set a 5-
byte value for 64-bit WEP or a 13-byte value for 128-bit
WEP. Hex keys must be preceded by 0x and contain 5 or 13
hex pairs.
7 Tap OK.
Configuring WPA-PSK Security With Profile Wizard
1 In the Profile Wizard, select the Security page.
2 For 8021x Security, choose None.
CN3 Series Mobile Computer User's Manual