Intermec CN3 Series User Manual page 34

Chapter 1 — Using the Computer
18
.
Changing the Volume of the Rear Speaker
Way to Adjust Volume
Tap the Volume ( ) icon
in the navigation bar.
Use Intermec Settings.
Press the side volume
control.
Note: For detailed information on the commands available in
Intermec Settings, see the Intermec Computer Command Reference
Manual (P/N 073529) available from the Intermec web site.
The CN3 has a built-in vibrate feature that enables you to receive
scanner feedback despite the noise level. When enabled, the CN3
vibrates when the scanner performs a good read or when the
phone receives a call.
To enable the vibrate feature
1 Tap the Volume (
2 In the Volume adjust box, tap Vibrate.
Procedure
Use the stylus to move the volume slider
up or down for the computer. You can
also turn the volume on or off and
choose to use Vibrate mode.
From the Start menu, choose Settings >
the System tab > Intermec Settings. Go
to Device Settings > Beeper > Volume.
Select the setting you prefer and save
your changes before exiting. For help, see
"Configuring the Computer With
Intermec Settings" on page
Press the top of the side volume control
to turn the volume up. Press the bottom
of the side volume control to turn the
volume down.
) icon at the top of the screen.
CN3 Series Mobile Computer User's Manual
48.