Entering Characters On The Qwerty Keypad; Entering Characters On The Numeric Keypads; Using The Power Button - Intermec CN3 Series User Manual

Chapter 1 — Using the Computer

Entering Characters on the QWERTY Keypad

Entering Characters on the Numeric Keypads

Using the Power Button

12
There are a few hidden characters on the QWERTY keypad that
require using the color-coded keys and the Shift key to access.
Use the following table to understand how to access these hidden
characters on the keypad.
QWERTY Keypad Hidden Characters
To Enter Press
Shift B Z
"
Shift B .
>
Shift B X
<
Above most of the number keys, there is a grouping of three or
four characters of the alphabet. For example, above the 2 key
there are the letters "ABC." To access each letter above the key,
you press the key one to four times depending on the placement
of the letter.
For example, to type the letter "c" you need to
• Press C 2 2 2.
To type a letter on the same key as the last letter entered, wait two
seconds, then enter the correct series of keystrokes to create the
next letter.
When you press the Power (
lower power mode. In this lower power mode, the CN3
continues to supply power to all memory, but turns off power to
most hardware such as the display. This power-saving feature is
designed to prolong battery life.
Note: If you do not have a SIM card installed, it may take up to
30 seconds for the CN3 to suspend.
) button, you put the CN3 into a
CN3 Series Mobile Computer User's Manual