Table of Contents
Advertisement
Performing the 1/f Noise Subsystem Functional Verification Test
If the performance of the Agilent 35670A dynamic signal analyzer is in
question, complete the following steps to verify operation.
To perform the RF subsystem functional verification test
Step
1 Activate the dynamic
signal analyzer.
2 View the results.
Installation and User's Guide
Action
a Connect the dynamic signal
analyzer to line power.
b Switch on the line power.
a Observe the results on the analyzer
display.
1/f Noise Subsystem Functional Verification Test
Notes
The instrument performs the self test during
power-up.
If the instrument self test fails, consult "Chapter
4. Troubleshooting the Analyzer," in the Agilent
35670A dynamic signal analyzer service guide.
E
135
Advertisement
Table of Contents
