Table of Contents
Advertisement
2
Installing the System
To connect the bias networks
Follow these steps to connect the bias networks to the system, and the
device under test to the bias networks.
Agilent 4156C Systems
To connect the bias networks
Step
1 For Agilent 4156C
systems, refer to the
following figure.
2 Connect the triaxial
cables from the 4156C to
the bias networks.
80
Action
a Connect the triaxial cables from the 4156C
HRSMU1 FORCE and SENSE connectors to
the DC FORCE and DC SENSE connectors
on the port 1 bias network.
b Connect the triaxial cables from the 4156C
HRSMU2 FORCE and SENSE connectors to
the DC FORCE and DC SENSE connectors
on the port 2 bias network.
Notes
•
From the rear of the system, route the
cable through the feedthrough panel.
•
The port 1 bias network is the 11612V
K11.
•
The port 2 bias network is the 11612V
K21.
•
Refer to
Figure 5
on page 29.
Installation and User's Guide
Advertisement
Table of Contents
