Removing And Replacing The Scan Engine - Intermec Sabre 1555 RFID Service Manual

Sabre 1555 RFID and Bar Code Reader Service Manual
8. Place the digital board assembly on the new RF board assembly. From the bottom
9. For a 2.4 GHz 1555, plug the antenna connector into the RF board.
The RF board assembly is ready to be installed in the lower shell. For help, see
"Reassembling the 1555" on page 2-30.

Removing and Replacing the Scan Engine

The scan engine is installed in the shield and chassis assembly on a 915 MHz 1555, and
in the antenna assembly on a 2.4 GHz 1555.
To replace the scan engine you need the following parts:
•
You need this tool:
•
2-20
of the RF board, install two Torx screws to secure it to the RF board assembly.
Torque the screws to 0.339 Nm (3.0 lb-in).
2.4 GHz
shown here
High-performance scan engine (P/N 591199-003) for 2.4 GHz 1555, or long-range
scan engine (P/N 590038-005) for 915 MHz 1555
Small Phillips screwdriver