Intermec Shell Startup Program Introduction - Intermec EasyCoder 501 S Installation And Operation Manual

Chapter 9
Intermec Shell Startup Program
Introduction
70
Intermec Shell is a startup program (also called "autoexec-fi le"),
which is a program that automatically starts running when the printer
is switched on. Intermec Shell helps the operator to choose between
a number of standard or custom-made application programs and to
start certain useful facilities, as listed below.
Application Programs
• Intermec LabelShop
• Intermec Windows Driver
• Intermec Fingerprint
• Intermec Direct Protocol
• LINE_AXP.PRG
• Other application programs in the printer's memory
A prerequisite is that the program is provided with the extension
".PRG". However, some original Intermec utility programs are
excluded as long as they remain stored in "rom:":
- ERRHAND.PRG
- ERRHAND910.PRG
- FILELIST.PRG
- MKAUTO.PRG
- TEST910.PRG
Other Facilities
• Terminal Setup
• Setup Mode
• Print Setup
• Testfeed
• Test Label
• Ser-Com Reset
• Clear RAM
• Reboot
Intermec EasyCoder 501 S – Installation & Operation Ed. 1
(WYSIWYG label design program)
(do not use)
(for creating your own programs or to
run the Intermec InterDriver)
(easy-to-use slave protocol)
(line analyzer program)
(remote setup ans Shell control)
(manual setup from printer's keyboard)
(printing setup on label)
(formfeeds + auto-adjust of the LSS)
(printing of test labels)
(resetting all setup parameters to default)
(erasing the printer's RAM memory)
(restarting the printer)
.
.