Intermec Shell Startup Program Introduction - Intermec EasyCoder 601 XP Installation And Operation Manual

Intermec Shell Startup Program
Introduction
1
/. A prerequisite is that the program is
provided with the extension ".PRG".
However, some original Intermec utility
programs are excluded:
ERRHAND.PRG
FILELIST.PRG
MKAUTO.PRG
Intermec EasyCoder 601 XP – Installation & Operation Ed. 3
Intermec Shell is a so called startup program (also called "autoexec-
file"), i.e. a program that automatically starts running when the printer
is turned on. Intermec Shell helps the operator to choose between a
number of standard or custom-made application programs and to
start certain useful facilities, as listed below.
Application Programs
• Intermec LabelShop
• Intermec Windows Driver (for printing Windows programs)
• Intermec Fingerprint
• Intermec Direct Protocol
• LINE_AXP.PRG
• LSS-SENSOR.PRG
• Other application programs in the printer's memory
Other Facilities
• Setup Mode
• Print Setup
• Testfeed
• Test Label
• Default setup
• Update PC-card
• Reboot
Intermec Shell is factory-installed in the printer's permanent
memory (device "rom:"). This implies that if you insert a memory
card with another startup file before you turn on the printer, or if
there is a startup file stored in the printer's permanent memory
(device "c:"), this startup file will be used instead of Intermec Shell
(see chapter 4;"Startup Files").
(WYSIWYG label design program)
(for creating your own programs)
(easy-to-use slave protocol)
(line analyzer program)
(LSS troubleshooting program)
(manual setup from printer's keyboard)
(printing setup on label)
(formfeeds + auto-adjust of the LSS)
(printing of test labels)
(resetting all setup parameters to default)
(downloading data from a computer to a PC-
card inserted in the printer, or upgrading the
printer's firmware from a PC-card)
(restarting the printer)
Chapter 9
1
67