75: Serial Out Parity; 98: Restore Factory Defaults, Print Self-Test, And Restore Previously Defined Settings - Intermec EasyCoder 4630 User Manual

Example: &%Z75,2
Sets the number of stop bits to 2.

75: Serial Out Parity

Purpose: Selects the parity of a data stream sent from the
interface card to the printer. This setting becomes
active the next time the printer is turned on.
Syntax: Z75,n
n =
0 None (default)
1 Odd
2 Even
Example: &%Z75,2
Sets the outgoing parity to even.
98: Restore Factory Defaults, Print Self-Test, and Restore
Previously Defined Settings
Restores the factory default configuration selections,
Purpose:
prints the active configuration settings, or restores the
nonvolatile memory settings.
Syntax: Z98,n
n =
0 Restores the factory setup
1 Prints the active configuration settings
2 Restores the settings stored in
nonvolatile memory
Example: &%Z98,1
Prints the active configuration settings.
Notes: To restore the settings in nonvolatile memory, place
&%Z98,2 at the end of the file.
2
Twinax Configuration
2-15