45: Scs Trn Translate; 55: Custom User Strings; Custom User Strings - Intermec EasyCoder 4630 User Manual

45: SCS TRN Translate

Purpose: Specifies how transparent data sent using SCS code 35
is handled.
Syntax: Z45,n
n =
0 Binary transparent
1 Emulate IBM 3287 printer (default)
Example: &%Z45,0
All SCS Code 35 data is sent to the printer as binary
codes without translation.
Notes: Value 1 causes valid graphic characters to be printed
normally (converted from EBCDIC to ASCII), while
control codes and invalid graphics are printed as
hyphens, and normal page formatting is maintained.
Value 0 causes the 8-bit binary codes to be sent
directly to the printer just as they are received from
the host.
SCS code 36 functions the same as code 35.
Available in SCS (LU1) mode only.

55: Custom User Strings

Purpose: Allows you to define a maximum of six custom
strings, up to 25 bytes each, that are stored in memory
on the interface card.
Syntax: Z55,n(command string)
n = 0 to 5
command string The hex codes of the ASCII
characters in the string enclosed in parenthesis.
Example: &%Z55,3(020D0A)
Defines a custom user string (U3) as
<STX><CR><LF> (02 0D 0A hex). This command
starts a new label format.
1
Coax Configuration
1-13