04: User-Defined Strings - Intermec EasyCoder 4630 User Manual

4630 and 4830 Coax/Twinax Interface Card User's Manual

04: User-Defined Strings

Purpose: Creates up to ten user-defined strings to send to the
printer. Place the hex codes representing the printer
command inside the parentheses (up to 25 hex pairs).
Syntax: Z04,n(hex codes)
n = 0 to 9
(hex codes) The user-defined hex code string to be
stored in the interface card memory under the
selected value number (0 to 9). To activate the
command, place &%Un (where n is the value number)
in the file.
( ) Deletes the specified user-defined string from
memory.
&%Z04,3(020D0A)
Example:
Creates a user-defined string to start a label. Hex
values 02, 0D, and 0A represent the ASCII control
characters <STX>, <CR>, and <LF> respectively. This
is string number 3 and to use it, you place &%U3 in
the file sent to the printer.
&%Z04,3( )
Deletes the user-defined command string
number 3.
2-10