Buffer Hex Dump - Intermec EasyCoder 4630 User Manual

4630 and 4830 Coax/Twinax Interface Card User's Manual
To start the self-test at the printer
1. Turn off the printer and make sure the proper 9-pin host adapter is
attached to the interface card.
2. Set the interface card rotary switch to position 7.
3. Turn on the printer.
To start the self-test from your terminal
1. Turn off the printer and make sure that the proper 9-pin host
adapter is attached to the interface card.
2. Turn on the printer and wait for the interface card LED to indicate
Line Sync.
3. Send the following command from the host to the printer:
&%Z98,1
If a self-test label does not print, the interface card failed the self-test
and you should contact your Intermec representative for more
information.

Buffer Hex Dump

The interface card can print the buffer contents as ASCII control
characters and in hexadecimal codes. This can be useful in diagnosing
problems with the label format, interface, or the printer. The EBCDIC
hex data is printed on a grid corresponding to the position of the data
in the buffer.
To start Buffer Hex Dump mode at the printer
1. Turn off the printer and make sure that the proper 9-pin host
adapter is attached to the interface and connected to the host.
2. Turn on the printer and wait for the ONLINE READY display.
3. Place the printer into Data Line Print mode (Service Menu, Data
Line Print, Enabled).
4. Set the interface card rotary switch to position #9.
3-4