Sending Commands To The Interface Card - Intermec EasyCoder 4630 User Manual

Sending Commands to the Interface Card

You can download commands from the host to configure the interface
card and to access advanced features. The commands take effect
immediately and stay in active memory when the file or screen print is
received by the printer.
For example, to change the LU1 language to French you would send
the following command:
&%Z08,11
where:
is the Command Pass-Thru delimiter.
&%
indicates a host download command.
Z
is the command number (LU1 Language).
08
is the separator between the command number and the
,
command setting.
is the command setting (French).
11
Multiple commands may be chained together using a slash (/) or a
backslash (\) to separate the commands. For example, to set the coax
buffer size to 1920 bytes (Z01,2), save the setting (Z99,0), and then
print a test label with the configuration settings (Z98,1), you would
enter:
&%Z01,2\Z99,0\Z98,1
Note: If any part of the command syntax is incorrect, the interface ignores
the command and the printer prints from the point of the syntax error.
1
Coax Configuration
1-5