Intermec EasyCoder 4630 User Manual page 33

2
Twinax Configuration
Position 7 Performs a self-test of the interface card, prints a label with
the self-test results, and then goes online with the host. This setting
takes effect the next time the printer is turned on.
Position 8 Restores the default settings of the interface card and then
prints a label with the default values. This setting takes effect the next
time the printer is turned on.
Position 9 Activates Buffer Hex Dump mode. In this mode, data
received by the printer is printed as ASCII control characters and in
hexadecimal notation. This mode stays active until another switch
position is selected (position A is recommended).
Note: To print labels in Buffer Hex Dump mode, the printer must be in Data
Line Print mode .
Position A Provides normal operation of the interface card using the
settings that are stored in saved memory.
Positions B and C Reserved for future use.
Position D Activates a Configuration mode where data cannot be sent
to the printer. Use this selection to configure the interface card without
printing labels.
Position E Activates Twinax Diagnostics mode. Disconnect the
twinax host cable from the twinax adapter attached to the interface
card before turning on the printer to run this test. A "Test Sequence
Complete" label is printed when test runs without problems. If a
diagnostic error is encountered during the test, an error label is
printed.
Position F Activates the twinax diagnostic fast loopback test. This test
is designed to be performed using an oscilloscope to evaluate board
performance. Disconnect the twinax host cable from the twinax
adapter that is attached to the interface card before turning on the
printer to run this test.
2-5