Ni-Max Application - Quantifi Photonics BERT 1005 Series User Manual

The following section details the various methods that a user may send these commands to an
BERT 1005 product via SCPI commands.

NI-MAX application

To communicate with any Quantifi Photonics PXIe or MATRIQ product, the chassis / instrument must
first be setup as a TCP/IP instrument.
1. After installing NI-MAX, launch the application. In the left side panel of the window, click the Devices
and Interfaces option. A drop down of available instruments detected will show up.
2. Click on Network Devices, then click Add Network Devices and select VISA TCP/IP Resource.
3. Select Manual Entry of LAN Instrument. Enter in the Hostname or IP Address. The top image is an
example of operating remotely, the bottom image is an example of operating locally. Note when
operating locally, enter in the localhost IP address of 127.0.0.1. Click Finish to end the setup process.
Quantifi Photonics Ltd. Version 2.04
Bit Error Rate Tester | BERT 1005
84