Table of Contents
Advertisement
5
Handling the BERT 1005
•
Do not remove the BERT 1005 product from the antistatic packaging until instructed
during the following installation procedure.
•
The BERT 1005 product is sensitive to ESD. Ensure you are wearing a grounded wrist
strap at all times when handling the BERT product to prevent damage from
electrostatic discharge .
•
Take care not to handle the optical connectors on the BERT, as once they are exposed
to skin contact this may leave corrosive residue which can damage the connector.
BERT 1005 PXIe module installation
DO NOT attempt to remove or adjust any component of the PXIe chassis while the power is
on. Ensure the chassis is powered OFF, and that the correct handling procedure detailed
herein is followed when removing or installing any modules.
STEP 1:
Power OFF the Chassis
STEP 4:
Push module into slot
until resistance is felt from the
backplane connection
After powering on the PXIe chassis, please wait at least 2 minutes before attempting to
communicate with the instrument. This will allow the chassis enough time to finish boot
procedures and initialize the communication server.
Quantifi Photonics Ltd.
STEP 2:
Remove the module
from the antistatic bag.
Retain bag
STEP 5:
Engage the
fastening clip. Secure all
fastening screws
Version
2.04
Bit Error Rate Tester | BERT 1005
STEP 3:
Align module with slot
guide rails
STEP 6:
Power ON the chassis
15
Advertisement
Table of Contents
