Table of Contents
Advertisement
2
Safety information
Before using the BERT 1005 product, ensure that the following safety information has been read and
understood.
Optical laser radiation precautions
Do not install or terminate fibers while the light source is active. Care must be taken to ensure
that the instrument has been turned OFF before inspecting the end face(s) of the instrument,
or any optical patch cords connected to this instrument. Never look directly into a live fiber;
ensure that your eyes are protected at all times.
The use of controls, adjustments, and procedures other than those specified herein may result
in exposure to hazardous situations involving optical radiation.
Electrostatic discharge precautions
The BERT 1005 product is sensitive to electrostatic discharge (ESD). Store the unused product in
the original protective electrostatic packaging that the product was shipped in.
Ensure that a wrist strap and grounding table mat is used when unpacking or handling the BERT 1005
product. Proper grounding and ESD management practices should always be followed to ensure that no
ESD damage is caused to the BERT product.
Electromagnetic compatibility
•
For electromagnetic compatibility, this instrument is a Class A product. It is intended for use
in an industrial environment. There may be potential difficulties in ensuring electromagnetic
compatibility in other environments, due to conducted as well as radiated disturbances.
•
Wherever the
device documentation for related safety information. Ensure that the required conditions
are met and understood before using the product.
Quantifi Photonics Ltd.
symbol is printed on the unit, refer to the instructions provided in the
Version
Bit Error Rate Tester | BERT 1005
2.04
8
Advertisement
Table of Contents
