Network And Update Settings Controls For Matriq Instruments; Configuring The Network Interface Settings For Matriq Instruments - Quantifi Photonics BERT 1005 Series User Manual

7.5.2

Network and Update settings controls for MATRIQ instruments

The network configuration control panel enables the user to set the preferred communication interface
(Ethernet or USB).
The Network interface controls are only available when connected over USB.
7.5.3

Configuring the Network Interface settings for MATRIQ instruments

The MATRIQ instruments can operate over either an Ethernet or USB connection. To communicate with
the instrument, the IP address is required. In order to configure ANY network interface settings, the
MATRIQ instrument will have to be connected via a USB cable to a computer.
The Network interface controls are only available when connected over USB. When connected
over Ethernet the settings will be locked, as highlighted as follows.
Quantifi Photonics Ltd. Version 2.04
Bit Error Rate Tester | BERT 1005
34