Scpi Multi Chassis Commands - Quantifi Photonics BERT 1005 Series User Manual

9.6.2

SCPI Multi Chassis commands

Changing the CohesionSCPI service Chassis Mode will rediscover all Chassis and installed
modules.
Command :SYSTEM:CHASSIS?
Syntax :SYSTEM:CHASSIS?<wsp>[LIST|MODE]
Description Query the Chassis Mode configuration
Parameters No parameters
LIST:
MODE:
Response
None:
In Single chassis mode:
SYSTEM:CHASSIS? -> 1
SYSTEM:CHASSIS? LIST -> 0
SYSTEM:CHASSIS? MODE -> SINGLE
Example
In Multi chassis mode:
SYSTEM:CHASSIS? -> 2
SYSTEM:CHASSIS? LIST -> 2,3
SYSTEM:CHASSIS? MODE -> MULTI
Command :SYSTEM:CHASSIS
Syntax
:SYSTEM:CHASSIS<wsp>[SINGLE|MULTI]
Description Set the Chassis Mode configuration
SINGLE: Set CohesionSCPI service to operate in SINGLE Chassis Mode
Parameters
MULTI: Set CohesionSCPI service to operate in MULTI Chassis Mode
Response No response
Example
SYSTEM:CHASSIS SINGLE
In Multi chassis mode, all the commands given above in the Specific Command Summary will still work,
but they must be prefixed with :CHASSIS<c>.
Common command example:
Single Chassis Mode
Multi Chassis Mode
Specific command example:
Single Chassis Mode
Multi Chassis Mode
Quantifi Photonics Ltd.
Returns a comma separated list of valid chassis index numbers discovered by
the CohesionSCPI service. These are chassis that have modules installed
Returns the current Chassis Mode the CohesionSCPI service is operating in
(SINGLE or MULTI)
Returns the number of chassis managed by the CohesionSCPI service. If
operating in SINGLE mode, this will always return 1
SLOT2:IDN?
CHASSIS1:SLOT2:IDN?
SOUR2:CHAN2:POW? MAX
CHASSIS1 SOUR2:CHAN2:POW? MAX
Version
Bit Error Rate Tester | BERT 1005
2.04 79