Table of Contents
Advertisement
2
Features and Functions
Carrier Waveform
62
Soft Front Panel Operation
Click Mod
and then select PM
Figure 2-
20. To output the PM waveform, configure the
settings for the carrier frequency, output amplitude, offset
voltage, modulating frequency, phase deviation, and the
desired waveform.
Figure 2-20 Panel view of PM
Remote Interface Operation
PM:STATe {0|OFF|1|ON}
The PM carrier waveform consists of Sine, Square, Ramp,
Triangle, or Arbitrary waveform. The default waveform is
Sine wave. You cannot use Pulse or DC as the carrier
waveform.
Soft Front Panel Operation
For Arbitrary waveforms, click Arb
as shown in
Figure 2- 2
from the drop down list
as shown in
at the top panel
and select the desired waveform
as shown in
U2761A User's Guide
Figure 2-
16.
Advertisement
Table of Contents
