Elevating Leg Supports - Otto Bock Start M2S Instructions For Use Manual

Settings
3) Install the cotter pin in the leg support.
Adjusting the lower leg length – version 2
1) Loosen the set screw on the locking mechanism (see fig. 36).
2) Adjust the leg support height (continuously variable). Ensure that the foot plate bar is inserted into the swivel
segment by at least 40 mm.
INFORMATION: A mark on the foot plate bar indicates the minimum distance the foot plate bar must
be inserted during installation.
3) Tighten the set screw on the locking mechanism to 8 Nm.
35
Adjusting the foot plate angle
1) Loosen the countersunk head screw on the foot plate (see fig. 37).
2) Turn the foot plate to the desired angle (see fig. 38).
3) Tighten the countersunk head screw to at least 6 Nm (see fig. 37).
37

6.8.2 Elevating leg supports

Installing the leg support
For removing and attaching the leg supports, see the instructions for use (user).
Adjusting the angle of the leg support
See the instructions for use (user).
Adjusting the lower leg length
1) Loosen the set screw on the locking mechanism (see fig. 39).
2) Adjust the leg support height (continuously variable). Ensure that the foot plate bar is inserted into the swivel
segment by at least 40 mm.
INFORMATION: A mark on the foot plate bar indicates the minimum distance the foot plate bar must
be inserted during installation.
3) Tighten the set screw on the locking mechanism to 8 Nm.
20
36
38
Start M2S, Start M2