Otto Bock 8E33 Series Instructions For Use Manual page 27

2) Dry the product with a lint-free cloth and allow it to air dry fully.
9 Maintenance
Performing regular maintenance (service inspections) every 24 months is recommended to pre­
vent injuries and maintain the quality of the product.
In general, all products are subject to compliance with the maintenance intervals during the war­
ranty period. This is the only way to maintain full warranty cover.
Additional services such as repairs may be provided in the course of maintenance. These addi­
tional services may be provided free of charge or can be billable according to an advance cost
estimate, depending on the extent and validity of the warranty.
The following components must be taken to the O&P professional on the agreed maintenance
dates:
The prosthesis, battery charger and power supply unit.
10 Legal information
10.1 Liability
The manufacturer will only assume liability if the product is used in accordance with the descrip­
tions and instructions provided in this document. The manufacturer will not assume liability for
damage caused by disregarding the information in this document, particularly due to improper
use or unauthorised modification of the product.
10.2 Trademarks
All product names mentioned in this document are subject without restriction to the respective
applicable trademark laws and are the property of the respective owners.
All brands, trade names or company names may be registered trademarks and are the property of
the respective owners.
Should trademarks used in this document fail to be explicitly identified as such, this does not justi­
fy the conclusion that the denotation in question is free of third-party rights.
10.3 CE conformity
Otto Bock Healthcare Products GmbH hereby declares that the product is in compliance with
European requirements for medical devices.
The product meets the requirements of the RoHS Directive 2011/65/EU on the restriction of the
use of certain hazardous substances in electrical and electronic devices.
The full text of the regulations and requirements is available at the following Internet address:
http://www.ottobock.com/conformity
11 Technical data
Ambient conditions
Storage (with and without packaging)
Transport (with and without packaging)
Operation
Charging the battery
Reference number
Operating voltage [V]
+5 °C/+41 °F to +40 °C/+104 °F
Max. 85%relative humidity, non-condensing
-20 °C/-4 °F to +60 °C/+140 °F
Max. 90% relative humidity, non-condensing
-5 °C/+23 °F to +45 °C/+113 °F
Max. 95% relative humidity, non-condensing
+5 °C/+41 °F to +40 °C/+104 °F
Max. 85%relative humidity, non-condensing
8E33=9-1 8E34=9-1
7.4
27