Otto Bock 8E33 Series Instructions For Use Manual page 25

2) The LED display on the charging receptacle provides information on the current battery
charge level.
Charging Event
receptacle
Battery fully charged (illuminated in green)
Battery 50% charged (illuminated in yellow)
Battery drained (illuminated in orange)
6.2.4 Beep signals
Beep signal
1 x long
2 x short
3 x short
7 Use
7.1 Switching the terminal device on and off
1
2
7.2 Torch
(for terminal devices with built-in torch)
Additional display
-
LED on charging
receptacle lights up
briefly
-
Switching off
1
Move the rocker switch to position 1 until it engages.
The electronics of the terminal device are switched off and the flex­
ion joint is blocked.
2
Switching on
Move the rocker switch to position 2 until it engages.
The electronics of the terminal device are switched on and the flex­
ion brake is released. When the flexion brake is released, the ter­
minal device can be moved by 45 ° in both directions.
1. 2x powerful LEDs
1
to light the working environment
2. On/off switch
2
to turn the LEDs on/off
Switching on: Press the button to turn the LEDs on. If this button
is pressed immediately after switching on, the brightness can be
3
changed in 3 levels by pressing it again.
Switching off: About 5 seconds after switching on, press the
button again to turn the LEDs off.
After about 15 minutes, the torch is switched off automatically.
3. Battery compartment
See the next section for battery replacement
Event
• Turn off prosthesis on charging receptacle
• Charging begins (charging plug connected
to charging receptacle)
• Charging ends (charging plug disconnected
from charging receptacle)
Switch on prosthesis
Battery voltage too low, prosthesis shuts off auto­
matically
25