Otto Bock AxonRotation 9S503 Instructions For Use Manual page 9

3.3 Contraindications
• All conditions which contradict or go beyond the specifications listed in the section on
"Safety" and "Indications for use".
3.4 Qualification
The product may be fitted only by qualified personnel authorised by Ottobock after completing the
corresponding training.
4 Safety
4.1 Explanation of warning symbols
Warning regarding possible risks of accident or injury.
CAUTION
Warning regarding possible technical damage.
NOTICE
4.2 Structure of the safety instructions
CAUTION
The heading describes the source and/or the type of hazard
The introduction describes the consequences in case of failure to observe the safety instruc­
tions. Consequences are presented as follows if more than one consequence is possible:
> E.g.: Consequence 1 in case of failure to observe the hazard
> E.g.: Consequence 2 in case of failure to observe the hazard
This symbol identifies activities/actions that must be observed/carried out in order to avert
►
the hazard.
4.3 General safety instructions
CAUTION
Non-observance of safety instructions
Personal injury/damage to the product due to using the product in certain situations.
Observe the safety instructions and the stated precautions in this accompanying document.
►
CAUTION
Independent manipulation of the product
Injury due to malfunction and resulting unexpected prosthesis actions.
Manipulations to the product other than the tasks described in these instructions for use are
►
not permitted.
The product and any damaged components may only be opened and repaired by authorised,
►
qualified Ottobock personnel.
CAUTION
Insufficient distance to HF communication devices (e.g. mobile phones, Bluetooth
devices, WiFi devices)
Falling due to unexpected behaviour of the product caused by interference with internal data
communication.
Therefore, keeping a minimum distance of 30 cm to HF communication devices is recom­
►
mended.
9