Technical Data - Otto Bock MyoSimulator 757T10 Instructions For Use Manual

2. Insert battery into battery receptacle and snap into place. The MyoSimulator is now
provided with power through the electrode connection and is ready for use.
3. Switch the flip-switch "OPEN / CLOSE" in the middle setting. Switch the flip-switch
"NORMAL / CO-CO NTRACTION / SAFETY CO-CONTRACTION" in the "NOR-
MAL" setting.
4. Set the "OPEN / CLOSE" knob in the "LOW" setting.
5. Set the flip-switch (Fig.1, Pos.9) in the "AUT." position. The System Electrohand will
open and close itself based on the given settings continuously in the OPEN – PAU-
SE – CLOSE sequence.
6. The time period for the OPEN – PAUSE – CLOSE sequence can be set with the
control knob (Fig.1, Pos.10-12).
7. The counter (Fig.1, Pos.1) shows the present number of completed movement cycles.
8. Setting the flip-switch (Fig.1, Pos.9) in the "MAN." Position will end the continuous
operation.
If you want to reset the counter to "0" then set the following controls:
Button OPEN / CO-CONTRACTION or
Button CLOSE / SAFETY CO-CONTRACTION or
Switch NORMAL / CO-CONTRACTION / SAFETY CO-CONTRACTION or
Switch OPEN / CLOSE
The continuous operation will start again, and the counter will read "0".
7

TECHNICAL DATA

Operating Voltage:
Operating Voltage Max.:
Stand by Current:
Operating temperature:
Output voltage Min.:
Output voltage Max.
Output voltage for Co-Contraction:
Output voltage for Safety Co-Contraction: 3,3V
Power source
8 Disposal
These products may not be disposed of with household waste in some jurisdictions.
Disposal that is not in accordance with the regulations of your country may have a
detrimental impact on health and the environment. Please observe the information
provided by the responsible authorities in your country regarding return and collection
processes.
16 | Ottobock
6V
8,4V
< 3mA
0 bis +50°C
0V
3,3V
3,3V
757B13/ 757B15/ 757B20/ 757B21/
757B25/ 757B35=*