Fuel Injection System Troubleshooting; Troubleshooting Chart - Yamaha Apex RX10PA 2011 Supplementary Service Manual

TROUBLESHOOTING CHART

Engine operation is not normal or the warning light and self-diagnostic warning indicator on the LCD flash.
* The warning light and self-diagnostic warning indicator on the upper LCD may not flash even if the engine
operation is not normal.
The warning light and self-diagnostic warning indi-
cator on the upper LCD flash.
Check the fault code number displayed on the
meter.
Identify the system with the malfunction. (Refer to
"Self-Diagnostic-Function table".)
Identify the probable cause of the malfunction.
(Refer to "Fault code table".)
Check and repair the probable cause of the mal-
function.
Fault code No.
Check and repair.
(Refer to "TROUBLE-
SHOOTING
DETAILS".)
Monitor the operation
of the sensors and ac-
tuators in the diagnos-
tic mode. (Refer to
"Diagnostic mode ta-
ble".)
Perform the fuel injection system reinstatement
action. (Refer to "Reinstatement method" in
"TROUBLESHOOTING DETAILS".)
Turn the main switch off, turn the main switch
back on, and then check if the fault code number
is still displayed.
Erasing the malfunction history:*
The malfunction history is stored even if the main switch is turned off.
The malfunction history must be erased in the diagnostic mode. (Refer to the "Diagnostic mode table (Di-
agnostic code No. 62)".)
* Operated when the warning light and self-diagnosis warning indicator flash.
FUEL INJECTION SYSTEM
No fault code No.
Check and repair.
Fault code number not displayed
Repairs completed
The warning light and self-diagnostic warning indi-
cator on the upper LCD does not flash.
Check the operation of the following sensors and
actuators in the diagnostic mode. (Refer to "Diag-
nostic mode table".)
d:01:Throttle position sensor (throttle angle)
d:02:Atmospheric pressure
d:03:Intake air pressure
d:05:Intake air temperature
d:06:Coolant temperature
d:07:Snowmobile speed pulse
d:09:Fuel system voltage (battery voltage)
d:30:Cylinder-#1 ignition coil
d:31:Cylinder-#2 ignition coil
d:32:Cylinder-#3 ignition coil
d:33:Cylinder-#4 ignition coil
d:36:Injector #1
d:37:Injector #2
d:38:Injector #3
d:39:Injector #4
OK
Engine malfunction
Check and repair
the inner parts of the
engine. (Refer to
CHAPTER 5.)
OK
Check the engine condition.
Fault code number
displayed
94
FI
NG
Defective sensor or
actuator
Check and repair the
corresponding sen-
sor or actuator.
NG OK
OK